Contents:
Fischer CNC-Technik GmbH
Oswald-Wiersich-Straße 16
D-67433 Neustadt an der Weinstraße
Tel. 06321-4999-0
Fax 06321-4999-22
Email: info(at)fischercnc.de
Registered office:
Neustadt an der Weinstraße
Court of registration Ludwigshafen Commercial register 41935
VAT No.: DE811224944
CEO:
Peter Helwig
Screen design, technical design, implementation with CMS System Typo3
C3 marketing agentur GmbH
Bahnhofstrasse 3
95643 Tirschenreuth
Email: info(at)myc3.com
Website: www.myc3.com
1. Website content Fischer CNC-Technik Gmb (referred to in the following as "Fischer CNC-Technik") accepts no responsibility for the topicality, correctness, completeness or quality of the information provided. Liability claims against Fischer CNC-Technik based on material or immaterial damage caused by the use or non-use of any information provided, including the use of any information which is incomplete or incorrect, are therefore excluded, unless there is evidence of wilful intent or gross negligence on the part of Fischer CNC-Technik. All offers are subject to confirmation and non-binding. Fischer CNC-Technik expressly reserves the right to change, supplement, delete or temporarily or permanently cease publication of parts of the website or the entire website without prior notice.
2. Links
In the case of direct or indirect links to external websites ("hyperlinks") which lie outside the area of responsibility of Fischer CNC-Technik, liability would only arise if Fischer CNC-Technik were aware of the content and if it were technically possible and reasonable for it to prevent use in the case of illegal content. Fischer CNC-Technik hereby expressly declares that at the time the links were created, no illegal content was identifiable on the linked websites. Fischer CNC-Technik has no influence whatsoever on the current and future design, content or authorship of the linked websites. For this reason it hereby expressly dissociates itself from all contents of all linked websites which were changed after the link was set. This statement applies to all links and references within Fischer CNC-Technik's own website as well as to entries by third parties in guest books, discussion forums, link directories, mailing lists, weblogs and all other forms of databases set up by Fischer CNC-Technik to which external write access is possible. For illegal, incorrect or incomplete contents and in particular for any damage resulting from the use or non-use of such information, only the provider of the linked website is liable, not the party that merely refers to the respective publication via links.
3. Copyright and trademark law
Fischer CNC-Technik endeavours to observe the copyright of the images, graphics, sound documents, video sequences and texts used in all publications, to use images, graphics, sound documents, video sequences and texts it has created itself or to make use of graphics, sound documents, video sequences and texts which are in the public domain. All brands and trademarks mentioned within the Internet offer and possibly protected by third-party rights are subject without restriction to the provisions of the applicable trademark law and the ownership rights of the respective registered owners. The mere fact that a trademark is mentioned should not lead to the conclusion that it is not protected by third-party rights! The copyright for any material created by Fischer CNC-Technik is reserved. Any duplication or use of material such as graphics, sounds or texts in other electronic or printed publications is not permitted without the express agreement of Fischer CNC-Technik.
4. Legal validity of this disclaimer
This disclaimer is to be regarded as part of the internet publication from which the user is referred to this page. If sections or individual terms of this statement are not or no longer legal or correct, the content or validity of the other parts will not be affected by this fact.
